Center Hinge Method - For Dry ApplicationĪfter measuring for placement secure your decal/graphic in the top corners with small pieces of tape. Remove the application tape by pulling from one corner 180 degrees against itself so as not to lift the decal/graphic from the surface. Starting in the center of the hinged side make overlapping strokes in each direction using firm pressure to apply the decal/graphic to the application surface. You can now flip the decal/graphic towards the hinged side to allow for removal of the backing paper to expose the adhesive surface. The basic hinge method is formed by placing tape half on a straight edge of the decal/graphic and half on the application surface. The hinge method also helps keep the decal/graphic from moving during application.Īfter measuring for placement secure your decal/graphic in the top corners with small pieces of tape.
By hinging the decal/graphic you will have control over the direction in which you are applying. The hinge can be on the top, bottom, left or right side of the decal/graphic. The basic hinge method creates a hinge between the decal/graphic and the surface it is to be applied to. Use one of the following installation techniques for application:.Rub across the application tape and vinyl with a squeegee to remove any air bubbles.Peel the backing off the application tape, and apply adhesive side of the tape to the vinyl.Cut a piece of application tape to the size of your design.Weed away excess material using tweezers or weeding tool.
Feed material into cutter so that the vinyl side is face up.
0 kommentar(er)
